Would you like to react to this message? Create an account in a few clicks or log in to continue.

pahelp naman po

2 posters

 :: General :: Help Line

Go down

pahelp naman po Empty pahelp naman po

Post by mysterious0072004 Mon Nov 07, 2011 9:28 pm

Mga sir ito kasi yung gusto kong gawin. Meron akong object tapos sa layout nakalagay dun yung front view, left view, top view at isometric view. Nakukuha ko na yung mga apat na views, yun nga lang using viewports. Pero kapag ginamit ko ang viewports meron siyang line. Ang gusto ko plain lang. Pano po ba yun? Baguhan lang po kasi ako thank you!more power



buttrock [img]pahelp naman po Unledqvu [/img]

mysterious0072004
CGP Newbie
CGP Newbie

Number of posts : 46
Age : 35
Location : rizal
Registration date : 10/05/2011

Back to top Go down

pahelp naman po Empty Re: pahelp naman po

Post by oRangE.n.GreeN Mon Nov 07, 2011 10:29 pm

.


AutoCAD ba?

your Viewport layer should non-plottable


.
oRangE.n.GreeN
oRangE.n.GreeN
CGP Guru
CGP Guru

Number of posts : 1078
Age : 97
Location : Sultanate of Oman
Registration date : 08/11/2008

Back to top Go down

pahelp naman po Empty Re: pahelp naman po

Post by mysterious0072004 Tue Nov 08, 2011 4:56 am

ahh ok sir thank you very much nagawa ko na hehehe

more power! 2thumbsup

mysterious0072004
CGP Newbie
CGP Newbie

Number of posts : 46
Age : 35
Location : rizal
Registration date : 10/05/2011

Back to top Go down

pahelp naman po Empty Re: pahelp naman po

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top


 :: General :: Help Line

 
Permissions in this forum:
You cannot reply to topics in this forum