The other Purpose of our HELP LINE

When you need a quick answer to your questions, the HELP LINE is here to help you. But make sure that you ask the question right, dahil hindi lang ang nagtatanong ang makikinabang sa sagot or explaination ng mga bagay bagay.

The HELP LINE also serves as a reference or answers to future questions by other members.

It is very important that words are spelled correctly so that the search engine will easily locate whatever a member is looking for. We hope that we use the help line properly.

Thank you.

And also if you are asking where to have this or where to have that, can you please check the resources/free stuff section.

Magandang Araw po sa Lahat ng Memeber..
Bago lang po ako.. Confuse kasi ako kung saan ako mag sisimula ng pag aaral ng vray. Sana po may makapag advice sa kin kung papaano..
Sana po may maka tulong sa akin.. Autocadd at Pag gawa ng 3d model ang
binubuhay ko sa family ko..
Thanks po at more power to all..

You may check the tutorials section for that. Tapos ask ka sa helpline pag meron kang hindi maintindihan. Good luck!

mga master new lang po ako na member ask ko lng po bakit ayaw lumabas nung visopt file sa sketch-up ni load ko naman po sa load setting ng v-ray option

master bokkins pwede po bang mag pa guide kung papano mag post gusto ko po kasi ma improve yung render ko po thanks.

Sir designline check mo sa forum posting rule kung paano mg post.

designline wrote:master bokkins pwede po bang mag pa guide kung papano mag post gusto ko po kasi ma improve yung render ko po thanks.

Please check

http://www.cgpinoy.org/t2-how-to-post